Resultado de búsqueda
The Alignment Manager™ Calculator comes with two distinct alignment software programs: the RIMFACE program, for use with either our #20RA or #30RA shaft alignment kits that follow the RIM-AND-FACE method of shaft alignment, and the REVDIAL* program, which utilizes the REVERSE-INDICATOR method.
Key To Variables: H = Swing diameter (circle of revolution) F = Face dial indicator orientation (plunger parallel to shaft) R = Rim dial indicator orientation (plunger perpendicular to shaft) D = Horizontal distance from parallel dial plunger to near feet of Motor-To-Be-Moved E = Horizontal distance from parallel dial plunger to far feet of ...
Two dial indicators are used to obtain numbers from the "moveable" side of a pump-coupling-motor assembly. By using two dial indicators, one mounted perpendicular to the shaft (radial), and one parallel to the shaft (angular), we can correct for both a height difference ( radial ) between the two machines, and an angle difference between them ...
11 de feb. de 2023 · SKU: 30RA. $1,194.00. $1,144.00. Out of Stock. #30RA CONTENTS. Two (2) alignment frames, each with three (3) 1/2"-diameter mounting holes to mount the tubing. (1) x 18" length of #40 roller chain attached to each frame. (2) Dial Indicators. (2) Swivel Joints. (2) Dial Indicator mounting rods (connects to tubing via Swivel Joint)
11 de feb. de 2023 · Kit Contents: (2) alignment frames, each with three (3) x 1/2"-diameter mounting holes for mounting tubes. 18" of #40 roller chain attached to each frame. (2) Dial Indicators, each with (1) swivel joint and (1) mounting rod assembly. Dial Face: 0-50-0 | Per Revolution: 0.100" | Total Range: 0.250" | Dial Case Dimensions: 1-11/16"
Expressing alignment. Alignment parameters. S. ince shaft alignment needs to be measured and subsequently corrected, a method of quantifying and describing alignment condition is necessary. Traditionally alignment has been described in terms of dial indicator readings at the coupling face or position values at the machine feet. The
For shaft alignment, we typically use dial indicators with 0.250″ – 0.300” total travel. The plunger moves a needle clockwise when pushed in and counter clockwise when let out. The face can be rotated so that the needle points to zero.
