Resultado de búsqueda
Hace 2 días · Metallurgists need accurate specifications in order to correctly perform the necessary heat treatment of parts. This helpful guide, written by William Rassieur, Sales Leader at Paulo Heat Treating, is a useful tool to identify what details ought to be communicated to the heat treating expert.
Hace 3 días · Heat Treat Today publisher Doug Glenn talks with Mark Hemsath about hardening basics. Mark was formerly the vice president of Super IQ and Nitriding at SECO/WARWICK, and is now the vice president of Sales - Americas for Nitrex Heat Treating Services Learn all about the what, why, and how of hardening. This episode builds upon the first conversation in Part 1.
Hace 3 días · En la elección del termopar adecuado, toma en cuenta algunos factores que pudieran alterar su desempeño como: El rango de temperatura en el que estará en uso. El tipo de atmósfera al que estará expuesto. Posible interferencia eléctrica. La precisión requerida por la especificación aplicable, etc.
Hace 3 días · Heat Treat Economic Indicators: May 2024 Results. The four heat treat industry-specific economic indicators, gathered by Heat Treat Today each month since June 2023, indicate expectations for ...
Hace 2 días · Getter materials are the MVPs that step up to the plate to protect work in a low-pressure vacuum environment. Table 1 [1] Getter Capacity of Common Materials. The folks at VAC AERO International have provided a primer on getter materials which answers the heat treater’s questions, such as: What is a getter?
Hace 4 días · Heat treatment changes the microstructure or surface chemical composition of the workpiece to improve performance, enhance mechanical properties, relieve residual stress, and improve machinability. Heat treatment processes are classified into preparatory heat treatment and final heat treatment based on their purpose.
Hace 3 días · The last piece of maintenance to be addressed in this paper is the proper mixing of a polymer. Water should be added to the tank first. Once the water level reaches approximately ¾ of the full level, the water additions can end. The next step is to agitate the water while slowly adding in the polymer.
