Yahoo Search Búsqueda en la Web

Entrar

Resultado de búsqueda

  1. support.industry.siemens.com › forum › wwFAULT NO. F30001 - 42345 - Industry Support Siemens

    10 de abr. de 2010 · I have to be done a project before 3 month ago on SINAMICS S120 series with IFK7032-5AK71-1DA2 motor. But yesterday a Motor Module give a Fault No. F30001 (Overcurrent). This fault is occur when motor module recive the run command signal from PLC & Control Unit.

  2. support.industry.siemens.com › forum › wwF30001 overcurrent fault in Sinamics S120 Drive for traction ......

    25 de nov. de 2016 · F30001 overcurrent fault in Sinamics S120 Drive for traction application. When Drive runnuing at more than 28HZ there is contineous fluctuation in current also frequency feedback from motor is fluctuating 27-29HZ for setpoint 30HZ & more.

  3. support.industry.siemens.com › forum › wwSinamics S120 Fault 30005 - 243183 - Industry Support Siemens

    14 de ago. de 2020 · Today I found the Fault 30005 for this axis: Motor Module 6SL3120-1TE28-5AA3, Motor 1FT7108-5SC70-1CH1. I was reading, in other posts, about the same fault and to check P0294, P0290 and r0036; in this case I have: P0294=95%, P0290=0, r0036=200%.

  4. support.industry.siemens.com › tf › WWG120 F30001 overcurrent - 171526 - Industry Support Siemens

    After this fault (F30001) I have problems restarting the motor (only with flywheel from 0 speed) when I try it goes to about 50rpm, current limiter turns on and after three seconds it gives a fault f07900 - motor blocked.

  5. cnctoolsllc.com › blogs › new-blogFault Codes and Alarms to Sinamics S120 — cnctoolsllc

    10 de ago. de 2023 · Faults and Alarms list of Sinamics S120. F01000: Internal software error. Check: POWER ON. React: OFF2. Message Value: %1. Object Drive: All objects. Reason: During a Floating-Point data type operation, an exception occurred. The problem might be produced by the core system or an OA application (for example, FBLOCKS or DCC). Solution:

  6. cache.industry.siemens.com › dl › filesSINUMERIK 840D sl, SINAMICS S120 5 Alarms 6 7 8 9 A - Siemens

    Fault • The appropriate fault reaction is initiated when a fault occurs. • The following measures are required to remove the fault: – Removing the cause of the fault

  7. support.industry.siemens.com › forum › wwfault in sinamics - 171259 - Industry Support Siemens

    17 de jul. de 2017 · ambient air temperature is high by some reasons; the system (inside S120) that observes temperature of its electronic has a malfunction itself. Also pay attention to following params: p0294 (factory setting=95%), min=10%, max=100%. If this value exceeds it causes - F30005;